Collectors Edition Saber – KR OWK Knight EP2

KR Sabers is on of the most the most sought-after and collected saber makers in not only the UK but the whole world. He has teamed up again with One Replicas to produce this incredibly accurate Obi Wan Inspired hilt from Episode 2 “Attack of the Clones” . Made from AL6061 and Brass, the brass parts have been beautifully chrome plated giving the hilt a very hefty feel. Installed by Blackstar Sabers with a 3d printed chassis by Goth3Designes. This sabers comes with a 1″ x 36″ blade. This saber is not designed for duelling. Collectors edition magazine included.

Hilt: KR OWK knight
Chassis: Goth 3D Eco Chassis
Installed By: Blackstar Sabers
Control Board: Proffieboard v.2.2.
Blade Fitting: 1 Inch Neopixel
Blade Programming: 132 pixels, Data Pad 1
Neopixel Connector: Shtok 7 Pin
Battery: KeepPower 18650 3.7 volts, 15 amp maximum discharge, protected PCB
Speaker: KR Sabers, 28mm, 2 watt, 4 ohm
LED Time Out Delay: 15 minutes
LED Wiring Layout: LED Pad 2/3, Data 1 Main Blade

Hilt Length – 28 cm
Default Blade Length – 36″
Other Blade Options – 32″ and 28″
USB-C Charging
Includes charger, screws and hex key