Collectors Edition Saber – KR Revan V2.0 Crystal Chassis

KR Sabers is on of the most the most sought-after and collected saber makers in not only the UK but the whole world. Here we have his take on Darth Revan’s epic saber . Made from AL6061 giving an authentic feel and beautiful finish. Installed by Blackstar Sabers with a completely removable eco cc 3d printed crystal chassis by Goth3Designes. This sabers comes with a 1″ x 36″ blade. This saber is not designed for duelling. Collectors edition magazine included.

Hilt: KR RVN 2.0
Chassis: Goth 3D Eco CC crystal Chassis
Installed By: Blackstar Sabers
Control Board: Proffieboard v.2.2.
Blade Fitting: 1 Inch Neopixel
Blade Programming: 132 pixels, Data Pad 1
Neopixel Connector: Shtok 7 Pin
Battery: KeepPower 18650 3.7 volts, 15 amp maximum discharge, protected PCB
Speaker: KR Sabers, 28mm, 2 watt, 4 ohm
LED Time Out Delay: 15 minutes
LED Wiring Layout: LED Pad 2/3, Data 1 Main Blade

Hilt Length – 30 cm
Default Blade Length – 36″
Other Blade Options – 32″ and 28″
USB-C Charging
Includes charger, screws and hex key