Collectors Edition Saber – KR X OR KRORSSGUARD

KR Sabers is on of the most the most sought-after and collected saber makers in not only the UK but the whole world. He has collaborated with One replicas to produce one of the most accurate and beautiful Kylo ren inspired hilts to date. Weathered by Multiverse props and installed by Kyber Customs. This saber comes with a 1″ x 36″ main blade. It does not come with side blades. Main blade unstable sleeve and side blades from the proplicator are also availible at extra cost. This saber is not designed for duelling. Collectors edition magazine included

Hilt Length – 29cm
Default Blade Length – 36″
Other Blade Options – 32″ and 28″
USB-C Charging
Includes charger, screws and hex key

Hilt: KR KRORossguard
Chassis: Jimmys lightsaber junk with OLED screen
Installed By: Kyber Kustoms
Control Board: Proffieboard v.2.2.
Blade Fitting: 1 Inch Neopixel
Blade Programming: 132 pixels, Data Pad 1
Neopixel Connector: Shtok 7 Pin
Battery: KeepPower 18650 3.7 volts, 15 amp maximum discharge, protected PCB
Speaker: KR Sabers, 28mm, 2 watt, 4 ohm
LED Time Out Delay: 15 minutes
LED Wiring Layout: LED Pad 2/3, Data 1 Main Blade